APC Back-UPS CS BK350EI

Tea

27.03.2007. @ 14:28 #13316

Srpski receno, ukoliko koirstite kompjuter amaterski i nije pitanje "zivota i smrti" prezivljavanje podataka i sam HD, onda srdacno preporucujem ovaj model, medjutim ukoliko vam treba za neke ozbiljnije poslove, onda svakako morate izabrati neki napredniji UPS. +:koristan dodatak u uslovima koje pruza EDB, spasava od neocekivanog nestanka struje -:mana je sto nema stabilizaciju napona, pa se njegova korisnost svodi samo na to da zavrsite to sto radite cuvajuci to sto ste uradili, a na cuvanje komponenti od stalnih promena napona zaboravite. To ce vam pruziti nesto skuplji APC uredjaji

Dragan

#62992 #Komentar #UPS #APC

Srpski rečeno, to što je prethodni korisnik napisao nije tačno.Čak ima mogućnosti programiranja rada,što podrazumeva da li hoćete da ispravlja napon za veoma osetljive uređaje,da ispravlja napon za manje osetljive uređaje ili da to uopšte ne radi.In situations where the Back-UPS or connected equipment appears too sensitive to input voltage, it may be necessary to adjust the transfer voltage. This is a simple task requiring use of the front panel pushbutton. To adjust the transfer voltage, proceed as follows: 1. Plug the Back-UPS into the utility power source. The Back-UPS will be in a Standby Mode (no indicators lit). 2. Press the front panel pushbutton fully inward for 10 seconds. All indicators on the Back-UPS will flash to acknowledge going into Programming Mode. 3. The Back-UPS will then indicate its current Sensitivity Setting, as shown in the following table. 4. To select the Low Sensitivity setting, press the pushbutton until the yellow indicator is flashing. 5. To select the Medium Sensitivity setting, press the pushbutton until the yellow and red indicators (second and third from the top) are flashing. 6. To select the High Sensitivity setting, press the pushbutton until yellow and both red indicators (bottom three) are flashing. 7. To exit without changing the Sensitivity Setting, press the pushbutton until the green indicator is flashing. 8. Once in Programming Mode, if the pushbutton is not pressed within 5 seconds, the Back-UPS will exit Programming Mode; all indicators will extinguish.

MORATE BITI REGISTROVANI DA BI POSTAVLJALI POST!
napravite klasičan nalog ili se uloguj na postojeći
NAPOMENA: posle logovanja bićete automatski vraćeni na ovu stranicu
ili

1-KLIK LOGIN SA FACEBOOK NALOGOM

1-KLIK LOGIN SA TWITTER NALOGOM

1-KLIK LOGIN SA GOOGLE NALOGOM

NAJNOVIJE
/APC

Izaberite UPS koji odgovara vašim potrebama

#APC #Novost #Schneider Electric

pre 4 godine